a little cutting and grinding, and voila! a seat pan



so i drew one side to get the curve i wanted, then laid a sheet of paper over it, traced it, and transposed to the other side.


next came the seat.....so I am building this bike on a budget. I work at a golf course and my boss is nice enough to let me use the shop while building. The tools i have for fabrication are a chop saw, die grinders and cutting wheels, angle grinder, O2/acetylene torch, and a wire feed welder. so I take everything I can get. Where am I going with this.... above is a bottom pan from a broken trash receptacle from on a golf course... my new seat >;-)